....Innovation im Prüfbereich

Testing Equipment ......

Conical Mandrei Bend Tester

A practical unit to test the elasticity and elongation of various coatings. The sampie panel is clamped and bent by rotation of the roller frame onto the 200 mm length x 03 - 37 mm conical mandreI. This allows easy identification in a single operation the coating failure at specified diameter, over part or entire mandrellength.

Features

• Sturdy construction
• Long service life mandrei

Ordering references

Conical Mandrei Bend Tester

      Ref No

• 801                     Conical Mandrei Tester complete

Standards

• ASTM                  0522, D1737
• BS                       3900  E11
• DIN EN ISO       6860

Cylindrical Mandrei Bending Tester

The test is carried out by bending the coated sam pie panel around mandreis of different diameters until damage occurs. Procedures can be based on pass/fail or diameter to failure methods.

Features

• Max. panel size: 50 mm width x 1 mm thick
• Robust stainless steel mandreis, easy to install in seconds
• Sturdy pre-drilled frame ready to secure on workbench

Ordering references

Cylindrical Mandrei Tester

       Ref No

• 809    Cylindrical Mandrei Tester OIN/ISO/NF: set of mandreis 2-3-4-5-6-8-10-12-16-20-25-35 mm
• 809A Cylindrical Mandrei Tester ASTM: set of mandreis 1/8 - 1,4 - 3/8 - 1f2 - JA - 1 inch

Standards

• ASTM    D522
• DIN         53152
• EN ISO   1519
• NF          30-040
• SIS         184174